Products – Bluewater Manufacturing Inc.

  • SafetyRail Finishing Rail Extension

    Eliminating a trip hazard at the egress/ingress point of the ladder, the Finishing Rail Extension uses the 'D' extension to keep the bases away from the ladder landing. The Finishi...
    Read more
  • SafetyRail Leveling StepRail

    The StepRail enables a continuous run of SafetyRail 2000 when the roof steps up or down.      
    Read more
  • SafetyRail LP Outrigger

    The SafetyRail LP Outrigger is used to continue a run of BlueWater's SR2K when faced with obstructions such as ducting or conduit that a standard rail cannot be easily run through....
    Read more
  • SafetyRail SG2000 – Sliding Gates for Guardrails

    The SG2000 (patent-pending) Sliding Gate can be used in place of swing gates when there is not enough clearance to allow for a swing gate to open.  
    Read more
  • SafetyStrip

    Warn personnel of potentional bump points or to warn of any condition that needs safety or caution signage with the SafetyStrip by BlueWater. Bonds to numerous surface types and is...
    Read more
  • Securing Pin

    Designed to secure the rail to the base, Securing Pins ensure the rails are locked into place. In comparison to alternative systems using set screw fastening techniques, Securing P...
    Read more
  • Series 1047 90 Degree Elbow

    Series 1047 - The 90 Degree Elbow is designed to provide a joint between two pipes at right angles to each other. It is often used as railing ends or corners on a level installatio...
    Read more
  • Series 1048 Short Tee

    Series 1048 - The Short Tee is designed to provide a butt joint between two pipes at right angles to each other. This fitting is often used to join ensd uprights to the middle rail...
    Read more
  • Series 1049 Long Tee

    Series 1049 - The Long Tee is designed to provide a butt joint between two pipes at right angles to each other. It allows the through pipe to be joined inside the fitting, and is a...
    Read more
  • Series 1050 Railing Base Flange

    Series 1050 - The Railing Base Flange is designed to provide structural fixing to guardrail and balustrades. The holes are sufficient diameter to provide good fixing with either me...
    Read more