Page 3 - Bluewater

Basic HTML Version

Our gate system features a
uniquely strong single-pull, double
latching mechanism that meets
OSHA regulations. When secured
with the locking coupler, the hinge
post always holds the hinges
parallel to the latch post. Gates are
conveniently sized to match the
rail lengths.
Outriggers (Returns): Whether your
installation is 5’ or 1000’ in length, you
must have outriggers at the beginning
and end of the run (A). They should be
placed approximately 90 degrees to
the danger side (B).
Our easy-to-use
system complies with
OSHA’s requirement
for using toe boards on
some elevated work areas.
Each bracket slides on the rail
and fits easily over a toe board. For added strength
it tightens to the rail with a friction knob.
Our brackets are designed to mount on any
toe board, no matter how the base is
positioned.
The minimum toe board size is a 2” x 4”
piece of lumber. Check OSHA CFR 29 1910.23
and 1926.502 for these and other regulations.
Each 3’, 3-1/2’, 4’, 5’, 7-1/2’ and 10’ rail sections are constructed
of 1-5/8 inch steel tubing. When rails are secured to the base,
the height of the top rail measures 42” from the working
surface. Bright yellow safety Powder Coat finish is standard.
Every rail section is equipped with a tube containing
instructions on proper utilization of the
SafetyRail 2000 system.
Our base is the most versatile product in
the marketplace. It measures 21-1/4”
across, from outside of handle to
outside of handle. The 108 pound
cast iron base has four ports,
allowing the rails to be placed in
an infinite number of positions to
avoid roof obstacles such as drains or
duct work. Each port has slots that incorporate
the custom engineered positive locking system. The base
center features a lifting hook for use with the EZ Mover,
as well as handles for easy lifting and positioning. Should
you need to permanently mount the base, four holes are
available for anchor bolts.
Each base has cast-in reliefs for easy stacking and storage.
Each port has a drain hole and
rubber pads come standard
on the underside to protect the roof surface. When placing
the base on a slippery or wet surface we recommend
using the optional rubber pads for added stability.
IMPORTANT: Our
positive locking system
allows for quick visual verification that the
rails are locked into place. Friction lock systems DO NOT provide this verification.
Installation in 3 easy steps
A
B
A
3
1.
Position
bases into
desired
location
using the
EZ mover.
2.
Insert each rail into
base ports.
3.
Insert
securing pin
and lock into
place.
That’s all
there is to it!
One guardrail system.
Many uses.
w
Manhole barricade
w
Rail car platforms
w
Ramps
w
Construction sites
w
Dig Sites
w
Mezzanines
w
Assembly and break areas
w
Crowd control
w
Hoist areas
w
And more!
* SafetyRail 2000 has been tested by a licensed engineering firm and was documented to comply with all OSHA regulations
pertaining to guardrail (29 CFR 1910.23 and 1926.502). Test results are available upon request.
www.bluewater-mfg.com